Newtek TriCaster Advanced Edition User Guide Manual de usuario descargar pdf (Pagina 296)

Page | 284

FIGURE 328

This virtual multi-monitor effect depends on a single clip (played from a DDR) which is itself a montage

composed of a number of different looping video clips composited into a single frame (e.g., Figure 329).

FIGURE 329

FIGURE 330

Hint: A template clip (Figure 330) is supplied in the Clips>NewTek folder (as are several looping sample clips). You

can use the template as a guide to prepare similar clips with content positioned correctly for use with the Nightly

Show set, using in the software of your choice.

To configure the effect:

1. Assign your talent shot to Input A in the M/E tab

2. Put the looping montage clip you prepared in a DDR, and select that DDR as Input B.

This particular set was designed to work with all TCXD model TriCasters, including those supporting just two

primary sources. For TriCaster 8000 (only), which adds C and D inputs in M/E panels, the set has been

updated as follows to provide more ability:

 Input C targets the ‘virtual ticker’. Knowing this, you might for example use Input C’s positioner to

compose a LiveText feed (from a Network input) to correspond to the lower right quadrant of the

template clip (as seen in Figure 330 above). This would then be mapped to the ticker, allowing you

to update the virtual ticker remotely.

 Input D is mapped to the virtual ‘control room monitor displays’. Position another source to conform

to any of the numbered input areas of the template clip to replace the corresponding ‘screen ‘in the

virtual control room. This allows you, for example, to send live video switched in another M/E to one

of these monitors.

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 341 342

Sin comentarios

Newtek TriCaster Advanced Edition User Guide Manual de usuario Pagina 296