Newtek TriCaster Advanced Edition User Guide Manual de usuario Pagina 255

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 342
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 254
Page | 243
22.4.9 RECORD GROUP
FIGURE 289
Three buttons labeled REC, STRM, and GRAB are located in the RECORD group.
REC Pressing this button enables TriCasters Record feature. As a safety measure, pressing the REC
button when recording is underway does not stop recording. Instead, the CTRL button flashes to
reminds you that you must hold the CTRL button down while pushing REC to end recording.
STREAM Push to enable or disable TriCaster’s live streaming feature.
GRAB Push to store a still imaged grabbed from Program output using TriCasters Grab feature.
22.4.10 PTZ CONTROL
Joystick control over pan, tilt, and zoom for connected robotic cameras is also provided.
Note: Joystick operations do not affect stored PTZ preset values.
To delegate the joystick to control a PTZ camera assigned to a specific TriCaster input, hold down SHIFT
button on the control surface and press a button in the M/E Delegate group. (Afterward, the button
corresponding to the current PTZ camera selection will light whenever SHIFT is pressed.)
Pan: With SHIFT depressed, tilt the joystick left-right.
Tilt: With SHIFT depressed, tilt the joystick backward-forward.
Zoom: With SHIFT depressed, twist the joystick clockwise or counter-clockwise.
Focus: When Auto is off, and with SHIFT + CTRL both pressed, twist the joystick clockwise or counter-
clockwise.
o Auto Focus toggle: With SHIFT + CTRL held down, press the joystick button.
Preset selection:
o Use CTRL + LIVESET SHOT (1-4); add SHIFT to the above for presets (5-8).
Press CTRL + LIVESET ZOOM RATE to adjust the camera’s Animation Speed.
Hold down SHIFT and press the top joystick button to update the current PTZ preset (position, zoom
and thumbnail icon).
Vista de pagina 254
1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 341 342

Comentarios a estos manuales

Sin comentarios