Newtek TriCaster Advanced Edition User Guide Manual de usuario descargar pdf (Pagina 273)

Page | 261

22.7.9 PAN CONTROL

Several controls are nested above each fader, along with the matching OLED display group

for that audio input or source. Looking at Figure 313 you’ll notice that in the default

operating mode (PAN; See the previous section) the Audio 1A track’s display shows a VU

meter at left, and a PAN graph below the input label. Rotate the knob below the PAN graph

display to adjust PAN for the channel this source is on.

MULTI-CHANNEL PAN CONTROL

For a four channel source, such as an input set to SDI Embedded, TriCaster’s level knobs

each control two channels. An Artist Mix knob set can likewise be configured to control

“Audio1 AB” and “Audio 1 CD” (for example) to control the two channel pairs for a single

SDI source (see Section 22.7.17 for details).

In such cases, the PAN control knob adjusts the first channel by default (A, in this example) for the assigned

pair. To adjust PAN settings for the other channel in the same pair, press the SEL button (just below the OLED

in the same Knob Set group). This lights the button, and re-assigns the PAN control

on the surface to the associated channel.

Press the SEL button again to restore control over the first channel (the SEL button

light will go out.

GAIN A AND B (MIC TRIM)

To adjust MIC GAIN for a channel, press the CHAN button. Then push the button labeled SEL located to the left

of the fader for the channel you want to control.

The highlight behind the source label in the OLED display updates to show the newly selected source. In CHAN

mode, an additional control (labeled GAIN A or B) appears at right of the channel’s PAN control on the surface.

These GAIN controls correspond to mic trim controls found in TriCaster’s input Audio Configuration panels

(Audio Mixer tab). Press CHAN again to restore normal, single channel control, when done making

adjustments.

Hint: Although the GAIN control is shown for other source types, it really only has any effect on inputs configured

as Mic types in TriCaster’s audio input source selector.

22.7.10 TALK

Push the small ON button to the left of the knob to toggle the Talk (Talk Over) feature for Mic sources.

22.7.11 SOLO & MUTE

Two larger buttons labeled SOLO and ON (Mute) are positioned below the knob; that is, above each of the eight

faders (Figure 314). These two buttons are outside the Knob Set group, and thus independent of the mode

established by the of Knob Set selectors.

FIGURE 313

FIGURE 314

1 2 ... 268 269 270 271 272 273 274 275 276 277 278 ... 341 342

Sin comentarios

Newtek TriCaster Advanced Edition User Guide Manual de usuario Pagina 273