Newtek TriCaster Advanced Edition User Guide Manual de usuario descargar pdf (Pagina 177)

Page | 165

RATIO

A Ratio of 4:1 means that if input level is 4 dB over the threshold, the output signal level after compression

will be just 1 dB over the threshold. The gain (level) is reduced by 3dB.

Very high ratio settings are the reason for the word “limiter” is part of the title for this feature. The highest

ratio setting will effectively reduce any signal that would rise above the threshold all the way down to the

threshold level (with the exception of a brief period during a sudden increase in source loudness, as dictated

by the Attack setting).

ATTACK

Attack (like Release) is labeled in milliseconds. The setting represents the amount of time it takes for the gain

to change by a specified amount.

It would not be grossly incorrect to think of this setting as changing the slope of a graph depicting how

aggressively the compressor pursues the target value (defined by applying the Ratio setting to the amount

the signal surpasses the Threshold). Shorter values are more aggressive, while longer values are more subtle

(and tend to be less noticeable to the audience).

RELEASE

Release is similar to Attack in many ways, but refers instead to the speed with which the compression effect

is removed as a source signal falls back on its own so that it no longer exceeds the Threshold.

GAIN

Naturally, compression impacts the overall output level of the source or output. The Gain control allows you

to compensate, bringing the post-compressor/limiter signal back to a comfortable nominal range.

Hint: Different circumstances call for different Attack and Release strategies. For example, much less aggressive

settings could work nicely for vocals, but fail badly when applied to a snare drum. Many websites provide

suggestions on establishing the best compressor/limiter settings for different environments.

NOISE GATE

The Audio Mixer’s advanced options panel also include a configurable Noise Gate for each audio source, as

well as all outputs. This lets you ensure that unwanted low-level sounds are prevented from inadvertently

intruding into the mix.

SECTION 15.8 OUTPUT AND PRIMARY BUS CONTROLS

As has been discussed (Section 15.7.2), TriCaster provides four primary audio busses – Master 1 and 2, and

Aux 1 and 2. Each of these is represented by its own control group Audio Mixer’s output section, and regulates

sound sent to physical connectors or to ‘logical outputs’.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 341 342

Sin comentarios

Newtek TriCaster Advanced Edition User Guide Manual de usuario Pagina 177